Safety 1st Advancer Instrukcja Operatora Pobierz pdf (Strona 130)

Environmental Remediation Drilling

Safety Guideline

Page 130 of 132

CATEGORY INSPECTION ITEMS PASS FAIL N/A

ACTION

NEEDED

General

Drill rig meets regulations for transport on state/federal highways

(inspection sticker, license plate, etc.).

Documentation available to verify that rig was inspected prior to arriving at

ExxonMobil job sites.

Does the rig size meet job requirements?

Maintenance log available for previous 3 months to confirm proper

maintenance/inspection.

Exhaust

Exhaust system should be free from defect and routes engine exhaust

away from drill rig workers.

Fuels

Fuel stored in an approved and properly labeled container.

Fuel transfer lines free from signs of excessive wear and not leaking.

Refueling and transferring of fuel is performed in an approved area with

sufficient containment to prevent spillage.

Exclusion/

Work Zones

The exclusion/work zone is centered over the borehole and the radius

equal to or greater than the height of the mast (measured from ground

level).

The exclusion/work zone should be clear of tripping hazards.

Overhead

Obstructions

Except where electrical distribution and transmission lines have been de-

energized and visibly grounded, drill rigs will be operated proximate to

under, by, or near power lines in accordance with the following:

* 50 KV or less - minimum clearance of 10 feet

* 50 KV or greater - add 0.4 inches for every KV over 50 KV

* If voltage is unknown, maintain at least 20 feet of clearance.

While the rig is in transit, clearance from energized power lines will be

maintained as follows:

* Less than 50 KV - 4 feet

* 50 thru 365 KV - 10 feet

* 366 thru 720 KV - 16 feet

Rig Repairs

Repairs, when possible, are conducted offsite to reduce the risk of any

onsite incidents.

Specialized

PPE

When working at elevated heights, workers are to wear a fall restraining

device attached in a manner to restrict fall to less than six feet.

When working in wet/slippery conditions, all workers have a lug-type sole

or similar slip resistant sole, on their safety footwear to prevent slipping.

RECOMMENDED SPARE PARTS OR ITEMS TO BE SENT WITH DRILL CREW

DRILL RIG DPT RIG

Emergency Switch Emergency Switch

Drive Coupling Drive Caps

Shear pins/keys (for drive coupling) Cutter Head

Pump Packing Pull Cap

Pump Hoses Liner Cutter

Auger Bolts Rod to Cap Pins

Rod to cap pins Liner Holder (used while cutting)

Cutter Head

Spill Kit (5 gal. Bucket with oil dry and absorbent

pads)

Safety Latches, Hooks, Clamps

Split Spoon Cutter Head

Spill Kit (5 gal. bucket with oil dry and absorbent pads)

1 2 ... 125 126 127 128 129 130 131 132

Komentarze do niniejszej Instrukcji

Brak uwag

Safety 1st Advancer Instrukcja Operatora Strona 130

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Wózki dziecięce Safety 1st Advancer